What this service covers
This service covers full new driveways for new or existing homes, replacements of worn out driveways, extensions that add width or a parking spot beside the garage, and the approach, which is the section that connects the driveway to the street. Concrete walkways are included too. A walkway from the driveway to the front door is built the same way, just thinner and narrower, and is often poured at the same time so the two match.
Why the ground under your driveway matters
Much of the ground around Houston is clay that puffs up when it gets wet and shrinks back as it dries, so the soil under a driveway never sits completely still. That makes the parts you never see after the pour matter most:
- A well compacted base with no soft spots under the slab
- Rebar, the steel bars inside the concrete, which helps hold the slab together if the ground shifts
- Control joints, the straight grooves cut into the surface, spaced so cracks stay small and follow a planned line
- A slope that sends rainwater off the driveway and away from the house and garage
Permits, deed restrictions and city rules
Inside the City of Houston. Driveway work falls under a Residential Driveway, Sidewalk, or Curb and Gutter Permit from Houston Public Works, handled through the Houston Permitting Center. The city wants a project number, dimensioned site plans and a copy of your property survey. The plans are reviewed, the work is inspected, and the driveway has to match the approved, traffic stamped site plan. A lot in a floodplain also needs a separate floodplain permit, and paving on private property can need a paving permit of its own.
Outside the city limits. Spring, Cypress, Atascocita and Channelview are not cities, so outside the Houston city limits Harris County rules apply. The county requires a permit for a driveway in the county right of way, the strip of public land along the road, and a reinforced concrete culvert, the pipe that carries ditch water under the driveway, where a driveway crosses a roadside ditch.
Nearby cities. Each city sets its own driveway rules. For example, The Woodlands and League City require concrete driveways, and Sugar Land requires a concrete culvert where a driveway crosses a ditch. Each town page covers the local details.
Deed restrictions. Houston has no zoning, but many neighborhoods have recorded deed restrictions that can limit driveway width, material or placement, and the city helps enforce them. Copies are available from the Harris County Clerk. Your homeowners association may have its own review as well.
Permit rules and fees change over time, so before any work begins, your contractor checks the current requirements with the office that sets them.
How a driveway gets built, step by step
- The estimate visit. Your local contractor looks at the old driveway, measures the area, checks how water drains across the lot and talks through what you want, such as a wider driveway, a parking pad or a new walkway.
- Plans and permits. Where a permit is needed, a site plan goes to the city or county for review. Approval comes before any concrete is ordered.
- Tear out and haul off. The contractor breaks up and removes the old concrete or other surface.
- Grading and base. The ground is cut or filled to the right height, shaped to drain and compacted. A solid base is the main defense against the clay underneath.
- Forms and steel. Wood or metal boards are set along the edges to hold the wet concrete, and rebar or mesh is raised so it sits inside the slab rather than at the bottom.
- The pour and finish. Your local contractor pours the ready mix concrete, levels it and gives it a texture. A broom finish leaves fine lines that give tires and shoes better grip when the driveway is wet.
- Joints and curing. Control joints are cut, and the new slab is kept moist and protected while it cures and gains strength. In Houston summers fresh concrete dries out fast, so this step gets extra care.
- Inspection and cleanup. Where the permit calls for an inspection, it happens on that schedule. Forms come off and the site is cleaned up.
The crew tells you when it is safe to walk on the new concrete and when it can take the weight of a car. Waiting the full time matters, because concrete keeps gaining strength well after it looks hard.
What changes the price of a driveway
- Size. Most driveway work is priced by the square foot, so a long double driveway costs more than a short single one.
- Tear out. Breaking up and hauling away an old driveway adds labor, equipment and disposal.
- Thickness and steel. A thicker slab and more rebar use more material. Some cities around Houston set a minimum, and heavy vehicles call for more.
- Grading and drainage. Extra dirt work, a new slope or drainage changes add time before any concrete goes in.
- Culverts and approaches. A driveway that crosses a roadside ditch or meets the street in the public right of way adds work and may bring extra rules.
- Access. Tight side yards, long distances from the street or overhead obstacles make the pour slower.
- Finish. A plain broom finish costs the least. Stamped patterns, color and decorative borders add material and skilled labor.
- Walkways and extras. A walkway, a parking pad or a wider apron at the street adds square footage.
- Permits. Permit and plan review fees vary by city and county.
For a general range, the cost question below shares published 2026 figures from Angi. Your contractor's written estimate should break out each item above so you can compare quotes line by line.
When an old driveway should be replaced
Small cracks, a rough or flaking surface and a single broken panel can often be fixed. When cracks run across most of the slab, panels have sunk or tipped, or water pools in the same low spots after every storm, the base underneath has usually failed and patching the top will not last. Then the better answer is to tear out the worst sections or the whole driveway and replace them on a properly prepared base.
This is common on older homes. The median home in Houston was built in 1982 (Census ACS 2020 to 2024), so many driveways in the city have been through decades of ground movement and storms. Some nearby cities require a permit for driveway repair as well as new work. Slab lifting and leveling are not part of this service, so a sunken section is replaced rather than raised.
Related concrete services
If your driveway only needs crack filling, resurfacing or a few panels replaced, see the concrete repair page. If you want the driveway or a front walk to stand out with a pattern or color, stamped concrete can be poured as part of the same job.
To see every project we can help you plan, including patios and slabs, visit our page for concrete driveway contractors in Houston. When you are ready, request a free estimate and tell us your town, the rough size of the area and whether an old driveway needs to come out.
Common questions
How much does a concrete driveway cost in Houston?
According to Angi (updated May 2026), most Houston homeowners pay $2,662 to $14,297 for a concrete driveway, and the average project runs about $6,310. The price moves with the size of the driveway, how thick it is poured, the rebar (the steel bars inside the concrete), whether an old driveway has to be torn out and hauled away, and the finish you pick. A plain broom finish costs less than stamped or colored concrete. Permits and how easy the site is to reach can add to the total as well. Every driveway is different, so request a free estimate for an exact number on your project.
Do I need a permit for a concrete driveway in Houston?
For most driveways, yes, especially where the work touches the city right of way. Inside the City of Houston, driveway work needs a Residential Driveway, Sidewalk, or Curb and Gutter Permit from Houston Public Works through the Houston Permitting Center. As of November 2026, the Houston Permitting Center lists the fee as a minimum of $103 that can go higher. The application needs two dimensioned site plans and a copy of your survey, and the city reviews the plans and inspects the work. Outside the city limits, Harris County requires its own permit for a driveway in the county right of way. Rules and fees change, so your contractor confirms the current requirements before work starts.
How thick should a concrete driveway be?
It depends on where you live and what you park on it, because several cities around Houston set their own standards. A 2020 Bellaire city document calls for driveways 4 inches thick, using 3,000 psi concrete with number 3 rebar at 18 inch centers. Psi is a measure of how strong the concrete is. Stafford calls for at least 5 inches with number 3 rebar at 18 inches each way. An undated City of Pasadena detail sheet lists 3,500 psi concrete with number 4 rebar at 12 inches each way. Heavier vehicles call for a thicker, stronger slab. Your contractor checks your city's current standard and builds to it.