The slabs this service covers
A slab is a flat, level piece of concrete poured on the ground to carry something on top of it. This service covers four kinds.
- Shed slabs. A solid floor for a storage shed, workshop or backyard office, so the building sits level and off wet ground.
- Garage slabs. The floor for a detached garage or carport, poured to hold a car, a pickup or a heavy workbench.
- Parking pads. An extra spot beside the driveway for a boat, a trailer, an RV or a second vehicle.
- Addition slabs. The floor under a new room, a sunroom or an enclosed porch that joins the side of your home.
Full house foundations for new homes are a larger job with their own design process, and they are not part of this service.
Each slab is planned for its job. A shed floor carries far less weight than a pad that holds a loaded trailer, and an addition slab has to meet the floor height of the house it joins. An addition slab on clay usually needs an engineered plan and a permit, which your contractor confirms.
Why Houston ground changes how a slab is built
Soil surveys name the main Houston area soils as Beaumont, League and Lake Charles soils. All three are clay with high shrink and swell, so a slab on top of them gets pushed and pulled as the soil soaks up water and dries out.
Heavy Gulf Coast rain keeps that cycle going, and long stretches of 90 degree days dry the ground back out. Heat also matters on pour day, because a fresh slab that dries too fast comes out with a weaker surface. North toward The Woodlands, Montgomery County has sandier surface soils and more hard freezes than the rest of the area, so the ground there behaves a little differently.
What that means for your slab:
- Steel inside the concrete. Rebar, the steel bars set inside the slab, helps hold it together when the ground moves.
- A firm base. Soft topsoil and roots come out, and a packed base goes down so the slab rests on solid footing.
- Planned joints. Shallow cuts give the concrete a chosen place to crack, so cracks stay straight and tidy.
- Water moving away. The slab is set a little above the yard and sloped so rain runs off it and away from your house or garage.
Permits, deed restrictions and floodplain rules
Whether your slab needs a city permit depends on the job, and your contractor confirms it with the Houston Permitting Center before work starts. An addition slab is usually one piece of a bigger building project, so its permit questions are settled together with the rest of the addition.
Outside the Houston city limits, other offices set the rules:
- Unincorporated Harris County. In places such as Spring, Cypress, Atascocita and Channelview, Harris County counts paving as development that needs a permit, and no fill is allowed in a floodway.
- Humble. Concrete work needs plans submitted to the city's Building and Inspection office, and a floodplain development permit can be required even when a construction permit is not.
- The Woodlands. The 2024 Residential Development Standards say added paving needs approval first and may not extend into an easement. That matters for a new parking pad.
Houston has no zoning, so many neighborhoods rely on recorded deed restrictions, and the city helps enforce them. You can get a copy of yours from the Harris County Clerk. Read it, and any homeowners association rules, before you settle on a spot for a shed or a parking pad.
How a slab goes in, step by step
- Look at the site. Your contractor walks the spot with you, sees how water moves across the yard and checks how a concrete truck can reach it. Stakes and string mark the size and shape.
- Check the rules. Permit needs, deed restrictions and any HOA approval get sorted out before digging begins.
- Dig and grade. Grass, roots and soft soil come out, and the ground is shaped so the finished slab drains the right way.
- Build the base. Base material goes down and is packed firm.
- Set the forms. Boards are staked along the edges to hold the wet concrete and set its height. For an addition, they are set so the new floor lines up with the house.
- Place the steel. Rebar is laid in a grid on small supports so it ends up inside the concrete, not lying in the dirt. Under a room, a plastic sheet often goes down first to slow ground moisture coming up through the floor.
- Pour and finish. The concrete is placed, pulled level with a long straight board and worked smooth. A garage floor usually gets a smooth finish, and a parking pad often gets a light broom texture for grip in the rain. If a shed or garage will be bolted down, anchor bolts can be set in the wet concrete.
- Cut the joints. Control joints go in at planned spots across the slab.
- Let it cure. The concrete keeps gaining strength after it hardens, so it is kept from drying out too fast. The crew tells you when it is ready for a shed, a car or a trailer.
What affects the cost of a slab
- Size. A larger slab needs more concrete, more steel and more labor.
- What it will carry. A pad for a boat trailer or an RV usually needs more thickness and steel than a floor for a garden shed.
- Getting there. A slab at the back of a fenced yard may need the concrete pumped or wheeled in.
- Dirt work. A sloped yard, low spots that need fill or soft soil that has to come out all add work before the pour.
- Old concrete. A cracked slab or old pad that has to be broken up and hauled away adds to the job.
- Extras. A moisture barrier under an addition, anchor bolts, thicker edges or a special finish.
- Permits and drawings. Any permit, site plan or HOA review adds time and fees.
A good written estimate lists each of these on its own line, so you can compare quotes on equal terms.
Planning a slab that fits the rest of your property
A parking pad usually sits right next to a driveway, and the two should meet at the same height with a clean joint. If your driveway is cracked or too narrow, it can make sense to plan both at once. Our concrete driveways page explains that work. A shed or workshop slab often leads to a path or a sitting area out back, which our concrete patios page covers.
Every new piece of concrete changes where rain goes, so planning the slab, walkways and patio together keeps water moving away from your home. See the full range of concrete slab work across Houston on our homepage.
Getting your slab project started
These details make the estimate more accurate:
- What the slab will hold, such as a shed, a detached garage, a trailer or a room addition
- The rough length and width
- Where it will go and how a truck could reach that spot
- Whether old concrete has to come out first
- Any deed restriction or HOA rules you know about
We serve Houston and the towns around it across Harris, Fort Bend, Brazoria, Galveston and Montgomery counties. Call or use the estimate form, and we will answer your questions and help you plan the project. Contractors are checked for insurance before they take on work. The estimate is free, and you decide from there.
Common questions
Do I need a permit for a concrete patio or slab in Houston?
Permit needs depend on the job, and your contractor confirms with the Houston Permitting Center before work starts. The city lists flatwork inside the property line as a permit type it reviews, and paving on private property has its own permit. Its list of work that needs no permit does not name patios or slabs. Several nearby cities spell it out more plainly. Baytown requires a building permit for open patios and private sidewalks. Katy requires permits for sidewalks, driveways and patios. Missouri City requires a permit and a city inspection for patios and other flatwork. Your neighborhood deed restrictions can add rules of their own, so check those too.
How do concrete contractors charge?
Most concrete work is priced by the square foot for the finished job, not by the yard. A yard is how a ready mix plant sells the raw concrete, and the material is only one part of the cost. The square foot price also covers labor, forms, base preparation, reinforcement, finishing and cleanup. These things change the number the most:
- Tear out and haul off of old concrete
- Thickness and the amount of steel
- Grading, drainage and access to the site
- Decorative finishes such as stamping or color
- Permits
A written estimate should list each of these, so you can compare quotes fairly.
Why does concrete crack in Houston?
Most of the Houston area sits on clay soils, known as Beaumont, League and Lake Charles soils, that swell when wet and shrink when dry. With about 47 to 56 inches of rain a year across the area and long, hot summers, the ground under a driveway or patio keeps moving, and the concrete moves with it. Parts of Harris County have also sunk over the decades from groundwater pumping. Careful base preparation, rebar, control joints (the cut lines that tell concrete where to crack) and drainage away from the slab all help. They keep cracks small and tight, but no one can honestly promise that concrete will never crack.